I am using BGP to acquire routes from a Vendor connection via T1. I then use BGP to bring those routes into my network, where they are redistributed via EIGRP to the Intranet. The question I have is the following: I currently receive a route, lets say 192.168.55.0/24, but a group on my network is using an Internet facing application from this Vendor that uses an IP address(192.168.55.35) in that network, so I can't allow that entire /24 to get routed across the private T1. Is it possible to bring this into my network as somehting smaller, even possibly a /32, 192.168.55.26/32? I'm not fully versed on BGP, but if someone could point me in the right direction, I would appreciate it.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...