On my test lab I have 4 routers. All running BGP + local IGP. Three routers are in the same AS 100. Sh ip bgp on all three routers show the correct networks have been learned by bgp and when you do a SH ip route, two of the routers have injected the bgp external\local routes into the local routing table but one router has not. This router is the mid router between the two edge routers? any ideas?
The BGP best path looks good and should be installed in the RIB. I noticed that the IOS version is quite old, which might cause the issue. Can you do a "clear ip route *" and see if the bgp routes get installed in the RIB.
Harold Ritter Sr. Technical Leader CCIE 4168 (R&S, SP) firstname.lastname@example.org México móvil: +52 1 55 8312 4915 Cisco México Paseo de la Reforma 222 Piso 19 Cuauhtémoc, Juárez Ciudad de México, 06600 México
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...