I have a router running bgp. I am also multihomed. I want to force a single networks traffic out of one isp. when I enter the command i typed
example ip route 184.108.40.206 255.255.255.0 220.127.116.11 1. When I do a trace the traffic is still following bgp's learned route and not that of a default route. I do know that the metric of the bgp is currently 3. And that 3 is the result of many different characteristics. My default route was built and have a metric of 1. How do I make my static route more attractive than the route for bgp?
when a router gets a prefixed advertised by 2 different sources, it will install the one with the lower AD and the default AD of 1 for a static route is always lower than the default BGP AD of either 20 or 200.But don't forget that the router always chooses the longest match route to forward traffic so if you have a longer BGP prefix it will win over the static route.
Can you tell us which destination you want to reach and post the output of sh ip route and sh run | i ip route
for the same prefix will cause your router to load-balance.
As per-packet load balancing is always used for packets originated by the router itself, you should see the first traceroute packet replied by the first next-hop, the second packet by the second next-hop, etc.
You can check by
sh ip cef 10.87.120.135
sh ip cef 10.87.120.140
It's strange your IOS is not showing both routes when sh ip route command is issued.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.