04-05-2006 06:35 AM - edited 03-03-2019 12:18 PM
Dear All,
IN Cisco IOS, is there is seperated Scanners one for BGP and another one for MP-BGP!!! i beleive that because there is onlyBGP process per router so Practically there is only One Scanner also the output of show proc cpu | inc BGP shown that there is only one scanner running on the router while the router running BGP and MP-BGP session
155 4853192 28039604 173 0.00% 0.02% 0.00% 0 BGP Router
157 1834796 3016664 608 0.00% 0.01% 0.00% 0 BGP I/O
158 42596720 774281 55015 0.00% 0.31% 0.25% 0 BGP Scanner
So Kindly Clarify
--
Best Reagrds,
Mounir Mohamed
04-05-2006 07:18 AM
Mounir,
There is indeed one scanner for all address families.
Hope this helps,
04-05-2006 07:36 AM
Hello,
there is one Scanner process in software, but you can instruct it to scan different address-families at different frequencies. The config could be like this (not complete for a PE, just to show bgp scan-time):
router bgp 65000
bgp scan-time 20
neighbor 10.1.1.1 remote-as 65000
address-family vpnv4
neighbor 10.1.1.1 activate
neighbor 10.1.1.1 next-hop-self
bgp scan-time 15
exit-address-family
Hope this helps! Please rate all posts.
Regards, Martin
11-10-2016 12:15 AM
Dear Mr Martin,
I have same problem my 12416 router doing high CPU ..if i take full route then cup will be 100%.
Regards,
kowsar
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: