Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

BGP show command

Hi,

show ip bgp neighbors [address] advertise-routes

As per cisco website this command does not take into account any outbound policies you may have applied. In future Cisco IOS versions the command output will be changed to reflect the outbound policies.

Has it changed in IOS 12.3...?

Thx,

G

3 REPLIES
Cisco Employee

Re: BGP show command

Gaurav,

This behavior has been in the IOS for a while. At least 12.0T that I can remember.

Hope this helps,

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México 
Paseo de la Reforma 222 Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
New Member

Re: BGP show command

So I should be sure that the command shows the output after getting processed by the outbound policy engine..

right ?

Thx in adv

G

Cisco Employee

Re: BGP show command

The answer is yes, assuming you are running anything more recent than 12.0T.

Hope this helps,

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México 
Paseo de la Reforma 222 Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
366
Views
5
Helpful
3
Replies
CreatePlease login to create content