R1 R2 and R3 are IBGP nei with each other,,R2 and R4 are Ebgp nei,,R5 and R3 are Ebgp nei, when i configured wieght on R1 which is connected to R2 and R3 with ibgp nei, R1 is configured higher weight attribute with R2, which R2 should be preffered for outgoing traffic flow.
when i am trying to see output in sh ip bgp command, some routes are tracing from R2 and some are from R3, why is so that???? because if i am configuring higher weight towards R2 then all routes should go via R2 only.. isn't it??
on the next side, same R1, if i am configuring EBGP neigh with R2 and R3, its working fine..why is so that??
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...