Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

BGP

guys i am having issue...im setting bgp dampening on the router.....as soon as i issue command i get this message can someone please tell me

%BGP-3-BADROUTEMAP: Bad parameters in the route-map fromas applied for Dampeningmat

now how i am doing it

router bgp XXXX

bgp dampening route-map fromas

as soon i applied this i get the above message.....i dont see anything wrong why router is giving me this message again and again...can someone please explain...thanks guys

  • WAN Routing and Switching
2 REPLIES

Re: BGP

HI, [Pls RATE if HELPS]

As per Cisco,

%BGP-3-BADROUTEMAP: Bad parameters in the route-map [chars] applied for [chars]

The route map contains parameters that are incompatible with the intended operation.

Recommended Action: Correct the route map definition.

Kindly share the Route-Map Configuration to correct accordingly.

Hope I am Informative. Pls RATE if HELPS

Best Regards,

Guru Prasad R

Re: BGP

I have seen this behavior when you create a route-map but does not have any dampening set under it

Suggest you to configure something like this and see

route-map damp permit 10

match ip address prefix-list damp

set dampening 15 600 2500 200 .. if this is not set, we can see the above error

router bgp 2

no synchronization

bgp log-neighbor-changes

bgp dampening route-map damp

neighbor 10.10.10.1 remote-as 1

no auto-summary

HTH

Narayan

244
Views
10
Helpful
2
Replies