Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

BGP

When I run sh run on the router, I don't any information about BGP at all in the output. However, when I run sh IP bgp..., I can see the IBGP and EBGP information. I have security level of 15. Any reason why the 'show running config" does not include BGP info?

5 REPLIES

Re: BGP

Hi,

Is that only for BGP config or is it the same for IGP too ?

try "sh run | section bgp" or "sh run | begin bgp" or "sh run | in router bgp" et al...just curious..-:)

New Member

Re: BGP

It is for both IBGP and EBGP. Nothing shows at all.

Re: BGP

Hi,

run the below command , you will get all the BGP config info

#sh run | b r bgp

Regards

Karuppu

New Member

Re: BGP

Thanks for your help. But why

the BGP info doesn't show up if I don't use the output modifier?

Thanks.

Re: BGP

You may want to look at updating the IOS. I seem to remember someone else on here having the same issue until they updated. What type of equipment are you running and IOS version?

John

HTH, John *** Please rate all useful posts ***
447
Views
0
Helpful
5
Replies