Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Big Problems with Cisco 831

I have a Cisco 831 , and I want to reset it to the factory default. I am able to log into it with hyperlink but I can't seem to get it to do anything. I can't ping it from the network when I set the ip. In fact, after the router restarts the network light goes off, so I figured I messed something up and would just like to reset it like it was out of the box. Any help would be greatly appreciated.

1 REPLY

Re: Big Problems with Cisco 831

Check that you are in enable mode by looking at the prompt. Look for the hash (#) as in Router#

When you are in enable mode, just type:

write erase

confirm with enter, wait till ready and switch the router off and on. You are now back to factory default.

Regards,

Leo

178
Views
0
Helpful
1
Replies
CreatePlease to create content