Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bind IP with MAC

Respected Sir,

I want to bind IP with MAC Address in cisco router, that client can't change their IP Address from the same MAC Address.

Plz.Help.

Regards,

Tarun

4 REPLIES
Hall of Fame Super Gold

Re: Bind IP with MAC

Hi, you had asked this question already, the answer is the same, disable dynamic arp under interface, and configure static arp entries in global config.

Hope this helps, please rate post if it does!

New Member

Re: Bind IP with MAC

Sir,

according to your instruction, I have configrue. But not getting result. Configuration as follows-

interface GigabitEthernet2/0/4

description "Link To 55222"

switchport access vlan 7

switchport mode access

duplex half

speed 10

no arp arpa

---------------------

arp 10.230.8.10 0017.5982.b010 ARPA

Regards,

Tarun

Hall of Fame Super Gold

Re: Bind IP with MAC

This config goes on the router. It will not work on a switch unless it is a L3 switch and you enable routing.

New Member

Re: Bind IP with MAC

sir,

This is Cisco 3750 switch. Am I need to changed the configuration.

Regards,

Tarun

379
Views
0
Helpful
4
Replies