Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Binding E1

HI,

I want 8 mbps link. In this situation I want purchse one 2821 router and 4 VWIC-2MFT-E1 cards. How can I bind them so that It will work like one. Second,How can I load balance it.

Third, I have MWR 1941 router. How can I perform the above in this router . PLS Help ASAP.

2 REPLIES
Bronze

Re: Binding E1

Hi

You need to configure multilink in router, give single ip address in multilink IP address with mask /30 & configure routing.

let me know anything more you required, please rate this post.

this link also help you, you need consider serail interface instead of dialer interface.

http://cisco.com/en/US/tech/tk713/tk507/technologies_configuration_example09186a0080093c1d.shtml

-minu

Silver

Re: Binding E1

Hi,

You can use multilink concept to bind all these E1 to work like one.....

There is a documentation for you to tell how to bind them,

http://www.cisco.com/en/US/tech/tk713/tk628/technologies_configuration_example09186a00800a5efa.shtml

Itself enables the load-balancing of traffic from different links and allows some level of redundancy in case of a line failure on a single link.

Support of VWIC-2MFT-E1 on the platforms can be refered in the below document,

http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet09186a0080091b9c.html

Cisco MWR 1941-DC router will support VWIC-2MFT-T1-DIR and multilink operation will be the same as other platforms

http://www.cisco.com/en/US/products/hw/routers/ps4062/prod_installation_guide09186a00801c9330.html

Rate if does,

Rgs.

120
Views
8
Helpful
2
Replies