Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

binding multilink

Hi friends,

I have got an issue with bundling multilink with serial.

Here comes the Topology

7206-core router is connected to multiple 1700s & 1800s through multiple E1s.

All serials are binded to multilinks at Core router and 1700 or 1800s as well.

one of the client (1700) is having issues in binding with multilink

Troubleshooting done.

Changed the encaps to hdlc at both ends

result : working fine

changed encaps to PPP with out multilink

result : working fine.

when binding to multilink :

serial and multilink goes down.

Debug output :

May 21 17:02:48.304 IST: Se2/5:30 MLP: Request add link to bundle

May 21 17:02:48.304 IST: Se2/5:30 MLP: Adding link to bundle

May 21 17:02:48.304 IST: Se2/5:30 MLP: Bundle x.x.x.x.x in different multilink group

May 21 17:02:48.304 IST: Se2/5:30 MLP: Link not added to bundle

after seeing this debug out suspected E1 & multilnik mismatch issue.

changed E1 and binded to a new multilink at both sides.

Still same issue.

The media is MLLN.

IOS c1700-k9o3sy7-mz.123-1a.bin

Please guide.

7 REPLIES
New Member

Re: binding multilink

Could you post your config?

New Member

Re: binding multilink

hi

there is no much complecated configuration.It's as simple as below.

Core 7200

Controller E1 3/2

framing crc4

channel group 0 time-slots 1

interface serial 3/2:0

no ip address

encapsulation ppp

ppp multilink

ppp multilink group 1

interface multilink 1

ip address x.x.x.x x.x.x.x

ppp multilink

ppp multilink group 1

Customer

1700 - WIC2T

interface serial 0/1

no ip address

encaps ppp

ppp multilink

ppp multilink group 1

interface multilink 1

ip address x.x.x.x x.x.x.x

ppp multilink

ppp multilink group 1

circuit is a MLLN circuit.

any issues?

New Member

Re: binding multilink

any guidance?

Silver

Re: binding multilink

could you please change the framing

New Member

Re: binding multilink

hi shivlu,

tried changing but still same.

anyway thanx and i managed it somehow

Cisco Employee

Re: binding multilink

Well your config seems to fine and straightforward. This could be related to some software IOS thing. Just to narrow down the problem, try configuring the virtual-template and see if it works.

http://www.cisco.com/en/US/tech/tk713/tk507/technologies_configuration_example09186a0080093d69.shtml

HTH,

-amit singh

New Member

Re: binding multilink

thanx amit,

It looks alike IOS bug only.I changed the router (1761) with 1841 router.and it started working with same WIC 2t card.We are about to upgrade /change IOS and see. I will come back to you later

Ps :- rated you 5 ;)

182
Views
9
Helpful
7
Replies
CreatePlease to create content