Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

blank catalyst 3560

I hope someone can please help me, I have a catalyst 3560 series switch that was bought at a auction and the switch did not have the ios installed on it, I was able to get the bin file loaded on it and can get access to it through the console port but from what i have been able to find out about it the switch should have a web interface gui to set it up with please help on getting it installed into the switch, thanks in advance Dan

3 REPLIES
Hall of Fame Super Blue

Re: blank catalyst 3560

Hi Dan

It depends what you loaded onto the switch. If you loaded just the .bin file then you can only configure if from the CLI.

If you loaded the .tar file then that includes the html pages etc. needed to configure the switch via the web interface.

Jon

New Member

Re: blank catalyst 3560

How do i load the tar file into the switch is it loaded the same way as the bin file?

Hall of Fame Super Blue

Re: blank catalyst 3560

Dan

Attached is a link to 3560 configuration document that shows how to upload .tar file to switch.

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_25_see/configuration/guide/swiosfs.html#wp1073579

HTH

Jon

110
Views
0
Helpful
3
Replies
CreatePlease to create content