Say you have an router with stateful firewall .2 and a 3560 with .3. The standby address is .1. You use the router as the active state and the 3560 in standby. Is there a way to make so 3560 will not route any traffic if say someone configured their gateway to point to it? The goal is to have all the traffic go through the router/firewall unless it has failed then it will use the 3560 for local inter vlan traffic.
Re: Blocking traffic on HSRP inter face in standby.
Depending on how you're routing, perhaps you could make the 3560 see the best path as through the firewall router while it's up. I.e., someone could still set the 3560 as the gateway, but their traffic would still transit the firewall if the firewall was on-line.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...