Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bonded T-1's and 2811

Question is how much bandwidth should we see with a 2811 and an IMA bundle pack (AIM-IMA and 2 dual port VWIC-2MFT-T1.  We are utilizing 3 t-1's in this scenario, so one should expect a 4.5 by 4.5.  But I though I read that the 2811 could only handle up to @ 3.5 by 3.5, and that the 2821 was necessary to gain the max speed?  Is this true?

2 REPLIES
Hall of Fame Super Silver

Re: Bonded T-1's and 2811

Hello Ken,

if the ATM IMA can handle the three T1 you should be fine. However, ATM IMA has its own overheads so you cannot get 4.5 Mbps of user traffic.

the ATM IMA bundle with 4 E1 is declared supported on C2811 see table 8 in datasheet

https://www.cisco.com/en/US/prod/collateral/routers/ps5854/ps5882/product_data_sheet0900aecd8016fa68_ps5854_Products_Data_Sheet.html

so you should be fine

Hope to help

Giuseppe

Re: Bonded T-1's and 2811

There is no theoretical limit (other than the number of ports which you can stuff in) but for 2811, more than 2 T1s would start affecting performance (when used along with other services like access control lists (ACLs), quality of service (QoS), and IP Security (IPSec).

However, for most practical uses, you shouldn't face any issues

Cisco 2800 Series Performance

Platform

Recommended Performance with Services Enabled (IMIX traffic)

Cisco 2801

Up to 1 T1/E1/xDSL

Cisco 2811

Up to 2 T1/E1s/xDSL

Cisco 2821

Up to 4 T1/E1s/xDSL

Cisco 2851

Up to 6 T1/E1s/xDSL

See this

http://www.cisco.com/en/US/prod/collateral/routers/ps5854/prod_qas0900aecd80169bd6.html

446
Views
0
Helpful
2
Replies