Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

bonded T1 config

Can someone help with a bonded T1 (2xT1) configuration? Our ISP installed the lines then told us we're on our own. Now i have a line that's been activated and just sitting there. I just need the basic configuration in order to connect to the internet.

Thanks

2 REPLIES
Cisco Employee

Re: bonded T1 config

If you are looking for MLPPP, please check out this document. This document uses E1 as example, but it is the same with T1. Just ignore the ppp authentication chap.

http://www.cisco.com/en/US/tech/tk713/tk628/technologies_configuration_example09186a00800a5efa.shtml

HTH,

jerry

New Member

Re: bonded T1 config

Appreciate your help.

1864
Views
0
Helpful
2
Replies
CreatePlease to create content