Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bonded T1s with MFR :(

A friend of mine asked me correct his config and I have no clue. Here it is. The two serial are the existing bonded t1s. The telco added in 2 more bonded Ts that are supposed to just join into the working MFR1. I can't figure out how to configure the VWIC cards to run data and join MFR1. Thanks in advance.

controller T1 0/2/0

Framing esf

linecode b8zs

channel-group 0 timeslots 1-24

!

controller T1 0/2/1

framing esf

linecode b8zs

channel-group 0 timeslots 1-24

!

!

!

!

interface MFR1

description EMBARQ Multilink Frame Relay

ip address 4.2.2.2 255.255.255.252

encapsulation frame-relay IETF

frame-relay multilink bid EMBARQ

frame-relay interface-dlci 57

frame-relay lmi-type ansi

!

interface FastEthernet0/0

no ip address

duplex full

speed 10

no mop enabled

!

interface FastEthernet0/0.99

description Connection to Wireless with VLAN 99 TAG

encapsulation dot1Q 99

ip address 5.5.5.5 255.255.255.248

!

interface FastEthernet0/1

ip address 192.168.1.1 255.255.255.224

shutdown

duplex auto

speed auto

!

interface Serial0/0/0

description Connection 1 to EMBARQ MFR

no ip address

encapsulation frame-relay MFR1

no ip route-cache

service-module t1 timeslots 1-24

no arp frame-relay

!

interface Serial0/1/0

description Connection 2 to EMBARQ MFR

no ip address

encapsulation frame-relay MFR1

no ip route-cache

service-module t1 timeslots 1-24

no arp frame-relay

!

interface Serial0/2/0:0

no ip address

no arp frame-relay

!

interface Serial0/2/1:0

no ip address

no arp frame-relay

!

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Bonded T1s with MFR :(

Hi

Try this.....

int S0/2/0:0

encap fr mfr1

int S0/2/1:0

encap fr mfr1

This should work.

Regards

JD

2 REPLIES
Bronze

Re: Bonded T1s with MFR :(

Hi,

Your question is not clear. I think you have pasted the proper working configuration.

Can you please elaborate your issue to try to resolve?

Regards...

-Ashok.

With best regards... Ashok ----------- Pls kindly rate if helpful or answered your question.

Re: Bonded T1s with MFR :(

Hi

Try this.....

int S0/2/0:0

encap fr mfr1

int S0/2/1:0

encap fr mfr1

This should work.

Regards

JD

145
Views
0
Helpful
2
Replies