Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bonding ADSL and FastEthernet Interfaces

Hi,

This is my setup:

Cisco 2811 with FastEthernet0/1 connected to a G.SHDSL modem link, and an ADSL WIC interface connected to ADSL line.

I would like to bond the ADSL dialer interface (Dialer1) and the FastEthernet interface to use a single WAN IP address and allowing inbound/outbound load sharing/balancing across the two physical WAN links. I would like to be able to remotely access this router by telneting into the single WAN IP address and for the connection to use the bonded (ADSL+FastEth) interface.

If anyone has any information on how this can be configured on a Cisco 2811, it would be appreciated.

Here is a section of the config:

------

interface FastEthernet0/1

description G.SHDSL Internet

ip address g.shdsl_IP 255.255.255.252

ip load-sharing per-packet

duplex auto

speed auto

!

interface ATM0/0/0

no ip address

no atm ilmi-keepalive

dsl operating-mode auto

!

interface ATM0/0/0.1 point-to-point

description ADSL Internet

no snmp trap link-status

pvc 8/35

encapsulation aal5mux ppp dialer

dialer pool-member 1

!

!

interface Dialer1

ip address negotiated

ip load-sharing per-packet

ip nat outside

ip virtual-reassembly

encapsulation ppp

dialer pool 1

dialer-group 1

ppp authentication chap callin

ppp chap hostname username

ppp chap password password

!

-----

Thanks in advance.

Vasko.

1 REPLY

Re: Bonding ADSL and FastEthernet Interfaces

hi vasko

i dont think you will be able to bundle your ethernet and your dialer interface together to have a single logical wan link.

regds

339
Views
0
Helpful
1
Replies