Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

bonding on 2 g.shdsl interfaces

hy guys,

i have an 2801 router with two g.shdsl controllers : WIC-1SHDSL-V3 + WIC-1SHDSL.

the DSLAM G.SHDSL equipment supports bonding on multiple interfaces. the idea is how to configure this on the 2801 router ? i guess that both interfaces must appear as a single one. i heard about IMA on ATM but the ima-group commands doesn't exists here.

1 REPLY
Community Member

Re: bonding on 2 g.shdsl interfaces

Hi,

This SHDSL is an ATM based, it should be configured on atm interface mode.please clarify this dalsm is ip or atm based..

please go through this this may help.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0080087d54.html#81237

123
Views
0
Helpful
1
Replies
CreatePlease to create content