01-22-2008 12:27 PM - edited 03-03-2019 08:22 PM
Hi,
A new production router/perimeter router will have a 3M Internet link by bonding two T1 lines. How does a Multilink Frame Relay point-to-point configured? In the following attachment, int. Multilink 1 will not accept configuration for frame relay point-to-point. Much appreciate assistance.
01-22-2008 02:52 PM
Before getting into the details of the features, is the router on the other side also configured for either MLPPP or ML-FR ?
01-22-2008 03:05 PM
The data sheet from the ISP states, "Service Type: Multilink Frame Relay, with a dlci: (number)
On a separate sample sheet provided by the ISP:
"interface MFR0
no ip address
frame-relay lmi-type ansi
interface MFRO.# point-to-point (dlci#)
ip address x.x.x.x 255.255.255.252 (customer WAN Ip address)
frame-relay interface-dlci # IETF (dlci#)"
01-23-2008 01:13 AM
Ok, so you need MFR, that is supported starting 12.2(8)T:
http://cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a00804554eb.html
Which exact IOS and router do you have ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide