Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Silver

Booting issue

Hello,

I've a cisco 2611 router what shows the following output during the boot (and it's looped). I tried to enter to rommon, but I couldn't. Is there any procedure to recover the system?

System Bootstrap, Version 12.2(7r) [cmong 7r], RELEASE SOFTWARE (fc1)

Copyright (c) 2002 by cisco Systems, Inc.

C2600 platform with 98304 Kbytes of main memory

device does not contain a valid magic number

boot: cannot open "flash:"

an alternate boot helper program is not specified

(monitor variable "BOOTLDR" is not set)

and unable to determine first file in bootflash

loadprog: error - on file open

boot: cannot load "tftp:c2600-advsecurityk9-mz.124-13d.bin"

Thanks your help in advance

bye

FCS

2 REPLIES
Silver

Re: Booting issue

Hello All,

I successfully resolved this booting issue, the procedure was the following:

I try to reseat the memory modules but it didn't solved the booting loop in next step I remove the interface card result was same finally I unmount the network modulo too ( so all modular things were remved). And during the boot the router caught the Ctrl+Break key sequence and went to rommon, whe the cards were installed it didn't recognize Ctrl+Break. After it IOS upload using tftp.

And now the router is up and running.

Bye

FCS

142
Views
0
Helpful
2
Replies