branch connections to hq and dr using 2 different tunnels how to direct some routes to hq and other routes to dr using ospf
have a new setup for a branch that will be connected in our mpls in w/c hq and dr is the 2 manin hub, both hq and dr sites also has regional wan connection for regional connections to dc.
we are running single area ospf in hq and dr witth connection to each other using tunnel. now i have a reqyuirement that from branch to regional network it will use dr site to reach the regional network while traffic to hq subnets will directly use the hq connection.
here is my design i will create 2 tunnel on my branch for hq and dr connection but im not sure how can i manipulate the traffic in ospf to prefer dr tunnel to reach regional nerwork while hq tunnel to reach hq subnets, im planning ospf cost? any better idea.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.