Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Bridge from WIC interface to Ethernet Interface

Needing to bridge from my wic interface to an ethernet interface on a 2900 series router so that I can pass through the ip address given to the WIC, to my ASA so that I don't have to give my ASA a private range address. (Just like a service provider might do when bringing a T1 with managed router in to my prem)

Any help would be most appreciated.

Everyone's tags (4)
1 REPLY
New Member

Bridge from WIC interface to Ethernet Interface

After a little bit of further research, I realized this can be done by transparent bridging.

Set bridge-group on both interfaces I want to bridge against, and that takes care of everything.

277
Views
0
Helpful
1
Replies
CreatePlease to create content