Bridge IRB and MultiLink

[miklafferty]

Hello,

I am trying to bridge over multilink T1s to another router. It works fine except I need to route other traffic over the T1s too. Using the following interface setting seems to get the IP overridden by the BVI's.

interface Multilink 1

ip add 10.x.x.x

bridge-group 1

interface BVI1

ip address 2.2.2.3 255.255.255.0

Any ideas would be appreciated.

Regards

[Giuseppe Larosa]

Hello Mik,

if you need to use the link to route IP traffic you should look at L2TPv3

http://www.cisco.com/en/US/docs/ios/12_3t/12_3t2/feature/guide/gtl2tpv3.html

this is supported on ISR 2811 or above

Hope to help

Giuseppe

[miklafferty]

Giuseppe,

It looks like that will work perfectly for me. Thanks for the help.