Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bridge IRB and MultiLink

Hello,

I am trying to bridge over multilink T1s to another router. It works fine except I need to route other traffic over the T1s too. Using the following interface setting seems to get the IP overridden by the BVI's.

interface Multilink 1

ip add 10.x.x.x

bridge-group 1

interface BVI1

ip address 2.2.2.3 255.255.255.0

Any ideas would be appreciated.

Regards

2 REPLIES
Hall of Fame Super Silver

Re: Bridge IRB and MultiLink

Hello Mik,

if you need to use the link to route IP traffic you should look at L2TPv3

http://www.cisco.com/en/US/docs/ios/12_3t/12_3t2/feature/guide/gtl2tpv3.html

this is supported on ISR 2811 or above

Hope to help

Giuseppe

New Member

Re: Bridge IRB and MultiLink

Giuseppe,

It looks like that will work perfectly for me. Thanks for the help.

280
Views
0
Helpful
2
Replies
CreatePlease login to create content