Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Bridging async interface

Hi,

I have a C1841 with 2 WICs installed (BRI and a analogue modem/async). My goal is to put both the BRI and async interfaces into bridging mode. With the BRI interfaces this is no problem but with the async interfaces it apperently not possible (also not when I created dialer interfaces).

Has anyone a suggestion or knows a workaround?

Curious I am because I was unable to find any solution for this...

Thx Sander

1 REPLY
Bronze

Re: Bridging async interface

Refer to the document which gives a sample ISDN bridging configuration.

http://www.cisco.com/en/US/tech/tk801/tk379/technologies_configuration_example09186a008014bad2.shtml

106
Views
0
Helpful
1
Replies
CreatePlease to create content