Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Bridging over IP network

Hello,

We have to provide connectivity to one of customer over our IP network.Customer has wireless last miles at both locations terminating at their router's ethernet interfaces.Customer requirement is to use same IP subnet at both locations means bridging over IP network so kindly guide me for this , as one of possible solution could be L2TPv3 but we can't do configuration at our(SP) end due to some policy matters. What are other solutions which we can implement at customer equipments only.

Regards,

Mujeeb

7 REPLIES
Hall of Fame Super Gold

Re: Bridging over IP network

Try convincing you customer to use different subnets at the sites because bridging is inefficient, hard to configure and diagnose, an generally unreliable. Generally speaking, customers do not have a real requirement to run bridging, but they request it anyway because unable to configure their systems properly.

If that fails, try configuring bridging over GRE tunnel - this is not supported officlay by cisco, but may work.

New Member

Re: Bridging over IP network

Hello,

I have created GRE tunnel between both locations but unable to put tunnel interface into bridge-group while I have seen conf. of a cisco router in which bridge group was assigned to a tunnel interface.Kindly guide me in this regard.Is there any possibility to achieve same solution using BVI interface ?

Regards,

Mujeeb

Hall of Fame Super Gold

Re: Bridging over IP network

Hello,

exactly the possibility of placing a tunnel interface in bridge group is the one never officially supported by cisco, so if the router doesn't take the command, I'm afraid you have nobody to complain to.

New Member

Re: Bridging over IP network

Hello,

Thanks for the prompt response.Well any other solution to provide Transparent LAN Switching over an IP network.Would IRB or CRB would work for me ?

Regards,

Mujeeb

New Member

Re: Bridging over IP network

We have a similar situation and our solution right now is using Metro Ethernet. Ask your local telephone providers if they offer this. It's simply a L2 network through the provider. But be careful multicast's through the network. This solution is great for temporary applications and is not suggested for full production.

New Member

Re: Bridging over IP network

Hello Mujeeb,

Bridging over GRE works. Just configure the following (bridge group number must be the same as the BVI interface number):

bridge irb

bridge 1 protocol ieee

interface BVI1

ip address /an address from the bridged network/

interface Tunnel x

bridge-group 1

(the IOS will tell you that this is an undocumented, unsupported command)

interface FastEthernet x

bridge-group 1

You need to do this on both end.

New Member

Re: Bridging over IP network

Hello,

Yes , its working. Thanks to all of you.

Regards,

Mujeeb

322
Views
8
Helpful
7
Replies
CreatePlease to create content