Broadcom 57711 and Cisco GLC-SX-MM connectivity problem
I have a switch 3560G-12S with Multi-mode module GLC-SX-MM. In my premise i also have Dell PowerEdge R910 with 2 x 10GB port (Broadcom 57711) populated with 10GbE SFP+ Optical Transceiver, SR, LC Connector. I am trying to connect the 10G SFP+ to GLC-SX-MM using 5-meter Multi-mode, LC-LC, Fiber cable. But after connecting the ports there is no activity across the port.
I connected 10G SFP+ port on another R910 and the 10G ports worked correctly. I then checked all the GLC-SX-MM port by connecting to another 3560G-12S switch and the ports worked well. But as soon as i connect one GLC-SX-MM port on the cisco switch to a 10GB SFP+ port on the R910 the link does not activate. There is no network connectivity between the server and the switch through these connected ports.
Please suggest what can i do now?
Note: I also reconfigured 57711 from BIOS to operate at 1Gbps instead of 10Gbps. Still it did not work. Please help.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...