Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

brom> boot on 2960XR switch

We received a new 2960XR switch and on initial boot it goes into brom> mode.

CPU rev: B
Image passed digital signature verification
Board rev: 6
Testing DataBus...
***ERR -- Data bit 3: Expected = 0xfffffff7, Actual = 0xfffffff3, at addr 0x00000000.
Going to MayDay...
Xmodem file system is available.
flash probe successful
create ifs brom
create ifs bs

brom>

Is this the same as ROMMON mode?  I can't find too much out there on brom> mode.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Nope.  This process happens

Nope.  This process happens before ROMmon.  

 

This means your appliance is dead.  You may need to contact Cisco TAC and arrange for a replacement.

2 REPLIES
Hall of Fame Super Gold

Nope.  This process happens

Nope.  This process happens before ROMmon.  

 

This means your appliance is dead.  You may need to contact Cisco TAC and arrange for a replacement.

Community Member

Hi I have the same problem,

Hi 

I have the same problem, as I've fixed?

this is what it shows:

reset

Are you sure you want to reset the system (y/n)?y

System resetting...

CPU rev: B
Image passed digital signature verification

Board rev: 5
Testing DataBus...
***ERR -- Data bit 0: Expected = 0xfffffffe, Actual = 0xfffe, at addr 0x00000000.
Going to MayDay...

Xmodem file system is available.

flash probe successful

create ifs brom

create ifs bs

brom>

1494
Views
10
Helpful
2
Replies
CreatePlease to create content