Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

BSR ( Bootstrap rouetr ) configuration

Hi,

I want to know about BSR configuration in a VRFlite scenario. As per my understanding I need to put two commands at the router which I want to make the BSR :

ip pim vrf Multi_2 bsr-candidate

ip pim vrf Multi_2 rp-candidate

and at rouetr ( connecetd to receiver ) I just need to enable pim sparse-mode.

Please suggest me , whether this config is ok or I need to cinfigure something else. if this is ok then I am facing a problem . I am not getting rp at receiver side.

Thanks in advance.

Regds,

Ashutosh

132
Views
0
Helpful
0
Replies
CreatePlease login to create content