Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

BT E1 NTE 2M/X.21 flashing red error with Receiver is getting AIS for E1 ISDN30

I have a BT SWSS NTE 52D with a flashing red light on the 2M/X.21 indicator and out put on the E1 controller as:

E1 0/0/0 is down.

  Applique type is Channelized E1 - balanced

  Description: BT ISDN-30 IMBT Pilot [number]

  Transmitter is sending remote alarm.

  Receiver is getting AIS.

BT have checked the line (or something they have been unable to tell me exactly waht though!) and advised its an issue with the WIC card in the

Cisco 2821.

Has anyone come across this issue, can anyone advise of what could be causing the issue and if BT are fobbing me off?

Many thanks 

1 REPLY
Gold

BT E1 NTE 2M/X.21 flashing red error with Receiver is getting AI

Here are some hints and tips from Cisco:

http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a0080344194.shtml

Has this ever worked ?

1835
Views
0
Helpful
1
Replies
CreatePlease to create content