Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

burst calculation in CAR on ATM subinterface

Hi,

I would like to calculate a better burst value to implement with rate limit command on ATM subinterface.

We have a PCR equal to 10Mbps and I tought that the normal burst can be 10% of PCR/8 (125000 bytes) and the same for exceed burst.

Is it correct?

Thank you.

Regards.

Paolo

1 REPLY
Bronze

Re: burst calculation in CAR on ATM subinterface

I think it should be (PCR * 1.5)/8

Hope this helps.

90
Views
0
Helpful
1
Replies
CreatePlease login to create content