Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

burst config

Hi,

we would like to implement the burst setting on Fast ethernet. e.g.

normal: 10M

burst: 3M

do we use the "rate limited" to do it? please advise

Best regards

1 REPLY

Re: burst config

you need to either use QoS policing or CAR to configure the same

eg..

access-list 10 permit any

class-map match-all rate-limit

match ip address 10

Policy-map rate-limit

class rate-limit

police 10000 30000 confirm-action-transmit exceed-action-drop

int fa 0/1

service-policy output rate-limit

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12225see/scg/swqos.htm#wp1044737

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fqos_c/fqcprt1/qcfcar.htm

HTH, rate if it does

Narayan

120
Views
0
Helpful
1
Replies