cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
464
Views
0
Helpful
1
Replies

BVI interface and NME-16ES-1G-P

Richard Venn
Level 1
Level 1

Hello,

I need to write a config for a 3825 with a NME-16ES-1G-P installed. I want to use bothe Gig interface on the router to connect to 2 core switches with a BVI interface, as show:

interface GigabitEthernet0/0

no ip address

duplex full

speed 100

media-type rj45

negotiation auto

bridge-group 1

no shutdown

!

interface GigabitEthernet0/1

no ip address

duplex full

speed 100

media-type rj45

negotiation auto

bridge-group 1

no shutdown

!

interface BVI1

description Transit Vlan Interface

ip address 15.253.192.36 255.255.255.240

no ip route-cache cef

no shutdown

What I need to know can I then use the BVI interface to conect to the NME-16ES-1G-P, when issueing the "service-module [interface] session"

i.e

service-module BVI 1 session

Unforunatlly I can not get my hands on the kit prior to the install date so I can't test it out.

1 Reply 1

irisrios
Level 6
Level 6

Minimum required on the NME is 12.2(25)SEC.

see the following under the section "Table 6. Product Specifications" and "Cisco IOS Software"

http://www.cisco.com/en/US/products/ps5855/products_data_sheet0900aecd8028d15f.html

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: