Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

C1941/C2901 AC Power Supply replacement

We have a 1941 router in place and in production, when I would like to replace the power supply from 'C1941/C2901 AC Power Supply" to the "PWR-1941-POE=" to enable POE on the existing "4 Port GE POE EHWIC- 'EHWIC-4ESG-P"  module.

I would like to do this in the field over the weekend, Is there documentation out there on the power supply replacement procedures? 

My current software ver. is Version 15.1(4)M3, RELEASE SOFTWARE (fc1) and I would like to know if support for the hardware change is covered in this release?

Thank you.

Everyone's tags (5)
6 REPLIES
VIP Super Bronze

C1941/C2901 AC Power Supply replacement

Hi,

Have a look at table-7 in this link.

Minimum Cisco IOS Software Release 15.1(2)T for  Cisco 1900, 2900, and 3900 Series routers: IP Base License of the  Universal image

http://www.cisco.com/en/US/prod/collateral/routers/ps10536/data_sheet_c78-612808.html

You have 12.2(4)M3, you should be good to go.

HTH

New Member

C1941/C2901 AC Power Supply replacement

Reza,

Thanks so much!

VIP Super Bronze

C1941/C2901 AC Power Supply replacement

Hi Jerome,

If the response was helpful, please rate and close the treat, so others can benefit from it.

HTH

Cisco Employee

C1941/C2901 AC Power Supply replacement

Hi Jerome,

Please see the following step-by-step guides on replacing/installing power supples and PoE on ISR routers.

C1941:

1. Installing and Removing a Power Supply

http://www.cisco.com/en/US/docs/routers/access/1900/hardware/installation/guide/Inst_Upgr_Int_Mods.html#wp1054462

2. Installing Power over Ethernet

http://www.cisco.com/en/US/docs/routers/access/1900/hardware/installation/guide/Inst_Upgr_Int_Mods.html#wp1061465

SW is sufficient for EHWIC-4ESG-P, as Reza advised.

Kind Regards,
Ivan

**Please grade this post if you find it useful.

Kind Regards, Ivan Shirshin **Please grade this post if you find it useful.
New Member

C1941/C2901 AC Power Supply replacement

Ivan,

Thank you! This replacement documentation is perfect.

cheers

Cisco Employee

Re: C1941/C2901 AC Power Supply replacement

Welcome, Jerome!

PS: Could you also mark this as answered/resolved, please, so that others could also benefit from it later?      

edited by: Ivan

Kind Regards, Ivan Shirshin **Please grade this post if you find it useful.
2885
Views
10
Helpful
6
Replies
CreatePlease login to create content