c2801 problem with booting

ip912klp03 · ‎12-22-2006

Hi all. I've c2801 and after powering on router no boot automatically, each time i've to run it by command: boot.

Below is the bootup message that appears:

System Bootstrap, Version 12.3(8r)T8, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

PLD version 0x10

GIO ASIC version 0x127

c2801 processor with 262144 Kbytes of main memory

Main memory is configured to 64 bit mode with parity disabled

Readonly ROMMON initialized

rommon 1 >

Could you tell me how to fix this problem?

ankbhasi · ‎12-22-2006

Hi Friend,

I believe you config register value is not set correctly or your boot statement is not defined properly.

Can you issue a boot statement again and check the boot statement if it is not correctly set then confiure it to

boot system flash:

Make sure you enter correct file name when are in config mode.

Also once booted up please check if the config register value is 0x2102 or not and you can check that giving "sh version" command.If it is not 0x2102 set it to the same issuing command

router(config)#config-reg 0x2102

HTH

Ankur

ip912klp03 · ‎12-28-2006

Hi,

Thanks for your help.

It was not correct register vlue (0x0). After change on 0x2102 it's booting automatically.

Gregory