Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

C2921-VSEC/K9 - Can't configre crypto.....

Hi we have a 2921-VSEC/K9 running c2900-universalk9-mz.SPA.151-4.M4.bin

I can't configure any crypto settings.

"show licence feature" reveals:-

Feature name             Enforcement  Evaluation  Subscription   Enabled  RightToUse

ipbasek9                 no           no          no             yes      no

securityk9               yes          yes         no             no       yes

uck9                     yes          yes         no             yes      yes

datak9                   yes          yes         no             no       yes

gatekeeper               yes          yes         no             no       yes

SSL_VPN                  yes          yes         no             no       yes

ios-ips-update           yes          yes         yes            no       yes

SNASw                    yes          yes         no             no       yes

hseck9                   yes          no          no             no       no

cme-srst                 yes          yes         no             no       yes

WAAS_Express             yes          yes         no             no       yes

UCVideo                  yes          yes         no             no       yes

Do I need to 'activate' the securityk9 feature? If so, how please?

Many thanks in advance,

Matt.

3 REPLIES
VIP Purple

Re: C2921-VSEC/K9 - Can't configre crypto.....

Hi ,

The IP Base License wont have most of the Advanced Security Features Like Below:

a) IPSec VPNs.

b) DMVPN.

C) Remote Access VPN.

d) Zone Based Firewalling

And Others.

If You require Security Features, You Should Choose the Security License Software.

http://www.cisco.com/en/US/prod/collateral/routers/ps10616/white_paper_c11_556985.html#wp9001369

The instructions are at

http://www.cisco.com/en/US/docs/routers/access/sw_activation/SA_on_ISR.html#wp1097551

For example, if you put the license file on to a USB stick, the command will be along the lines of:

license install usbflash1:license-file-name.xml

Regards

New Member

Re: C2921-VSEC/K9 - Can't configre crypto.....

Thank you for the response Sandeep. I was under the impression that because the part number ordered was

2921-VSEC/K9, we should have the security licence pre-installed. This does not appear to be the case so my question is around activating a licence that I think we have purchased but does not appear to be activated?

Thanks,

Matt.

VIP Purple

Re: C2921-VSEC/K9 - Can't configre crypto.....

as per your output from sh lic feature:

it shows that its not enabled:

Enable or activate :

http://www.cisco.com/en/US/docs/routers/access/sw_activation/SA_on_ISR.html#wp1097551

or

http://www.rracuares.com/2010/07/31/activating-cisco-isr-g2-evaluation-license/

----------

Can you paste the output of this command: sh ver , sh flash

Lets see VPN module is there or not ?

Reagrds

147
Views
0
Helpful
3
Replies
CreatePlease to create content