05-27-2008 08:37 PM - edited 03-03-2019 10:07 PM
Hi Experts,
I have a switch which all the flash files have been deleted before shutting down... how can I bring up the switch?
currently it is in this mode:
switch:
switch:
I can't go to the running-config..
Thanks in advanced.
cindy
Solved! Go to Solution.
05-27-2008 10:09 PM
Hi Cindy,
Please follow the link below :
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml
HTH,
-amit singh
05-27-2008 10:09 PM
Hi Cindy,
Please follow the link below :
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml
HTH,
-amit singh
05-28-2008 12:29 AM
Thanks Amit,
Your link is helpful..
Able to boot to the IOS now.. but, how come when I did a reload it went back to the : switch: mode again?
I did a "boot system IOS" and also wr mem before rebooting.
Thanks for advise again.
cindy
05-28-2008 12:35 AM
Hi
Check u r config-register and u need.
from the switch:boot flash:ios
and in the config
boot system flash:ios
Thanks
Mahmood
05-28-2008 05:40 PM
Thanks guys! got it..rated you guys post..
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: