05-27-2008 08:37 PM - edited 03-03-2019 10:07 PM
Hi Experts,
I have a switch which all the flash files have been deleted before shutting down... how can I bring up the switch?
currently it is in this mode:
switch:
switch:
I can't go to the running-config..
Thanks in advanced.
cindy
Solved! Go to Solution.
05-27-2008 10:09 PM
Hi Cindy,
Please follow the link below :
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml
HTH,
-amit singh
05-27-2008 10:09 PM
Hi Cindy,
Please follow the link below :
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml
HTH,
-amit singh
05-28-2008 12:29 AM
Thanks Amit,
Your link is helpful..
Able to boot to the IOS now.. but, how come when I did a reload it went back to the : switch: mode again?
I did a "boot system IOS" and also wr mem before rebooting.
Thanks for advise again.
cindy
05-28-2008 12:35 AM
Hi
Check u r config-register and u need.
from the switch:boot flash:ios
and in the config
boot system flash:ios
Thanks
Mahmood
05-28-2008 05:40 PM
Thanks guys! got it..rated you guys post..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide