C881G [15.2(1)T] with Sierra 504-G modem. FW ver = K2_0_7_35AP C:/WS/FW Modem Firmware built = 03/04/10 Hardware Version = 1.0
There are several 3g cells visible. Signal strength is changing within 2-5 dB range. And occasionally Cell ID with best signal changes, which leads to the fact modem re-registers to another CELL ID and it causes freqient outages (due to the routing protocol and tunnel converge).
Is there a way to lock on to on specific Cell. Or configure some kind of threshold for the modem to initiate registering to another cell . Modem and Cellular controller configuration possibilities seems to be very limited.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...