I recently installed a memory license upgrade (FL-8XX-512U1GB) on a c891F ISR. The license install <filename> command reported successful installation. However, a show version command still reports 512MB of memory and the license information doesn't include anything about the memory upgrade license (post reload). Is there any command that shows that the router is, in fact, using the 1GB allowed by the license?
This link contains a table, memory options, that shows the 891F memory upgrade feature option: http://www.cisco.com/c/en/us/products/collateral/routers/800-series-routers/data_sheet_c78-519930.html
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.