Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cable for PA-MC-8TE1+= port adapter

Hi Sir,

For PA-MC-8TE1+= port adapter, can anyone confirm the correct cable is CAB-E1-RJ45BNC= (description: E1 Cable RJ45 to dual BNC (unbalanced), Spare)?

Thank you.

B.Rgds,

Lim TS

2 REPLIES
Hall of Fame Super Gold

Re: Cable for PA-MC-8TE1+= port adapter

If you are going to a 75 Ohm circuit using BNC, yes.

Hope this helps, please rate post if it does!

Re: Cable for PA-MC-8TE1+= port adapter

Hi,

The PA-MC-8TE1+ port adapter uses shielded twisted-pair cables with RJ-48C connectors to connect to a PBX or to the Public Switched Telephone Network (PSTN).

Refer to http://www.cisco.com/en/US/docs/interfaces_modules/port_adapters/install_upgrade/multichannel_serial/8-port_multichannel_t1.ei_8pri_install_config/2738ins.html#wp1031384

Regards,

Dandy

219
Views
0
Helpful
2
Replies