Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Cable for VWIC2-2MFT-T1/E1

Hello,

This WAN card has RJ-48C connector. Do we use Cat 5 cable to connect to this interface or there is any special cable?

Thanks

1 REPLY

Re: Cable for VWIC2-2MFT-T1/E1

You would need an E1/T1 cross over cable.

It is a cat5 cable in which pin 1 connects to 4 and pin 2 connects to pin5

http://www.juniper.net/techpubs/hardware/m40/m40-hwguide/html/pinout4.html#1017968

HTH

Narayan

762
Views
0
Helpful
1
Replies