Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cable needed for T3

Hi All,

Just got in some equipment with some of that being a NM-T3/E3 card. I have never installed a DS3, but from my reading, it looks like I may have been sent the wrong cable. The card has bnc connectors. Exactly what does a ds3 smart jack look like? the cable I was sent has bnc on one end and what looks to be almost like a serial connection on the other end. When DS3 are terminated, what do they look like?

TIA,

R

1 REPLY
Purple

Re: Cable needed for T3

Most DS3 cables that I have come across are co-ax with NBC termination. The other end of your cable is possibly what gets connected to the NTU supplied by your provider so I'm guessing that what you have is probably correct.

Paresh

97
Views
0
Helpful
1
Replies
CreatePlease to create content