Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cable Selection

Have a solution for Japan. 2811 router with possibly VWIC2-1MFT-G703. My question is where can I find detailed technical information on how to connect this router to a "J1" circuit. I have never designed for Japan before and have some trepidation.

3 REPLIES
Hall of Fame Super Gold

Re: Cable Selection

Hi,

In Japan T1 service can be delivered as either J1 or T1, depending on the telco.

On ISR routers like 2811, there is no interface available for data J1, not even the one you mentioned.

So in case the circuit is delivered as J1, you will need to use an external DSU with V.35 or other serial interface to the router.

Hope this helps, please rate post if it does!

New Member

Re: Cable Selection

Thanks, I'm hoping you can help clarify. Assuming it is T1, what interface would you use in the 2811 router? Currently, I have an VWIC2-12MFT-G703 interface in the router. I'm told by the circuit designer it will be G.703. Also, assuming that is correct what cable would you use for a connection? (I'm thinking RJ48 to RJ48 shielded)

Hall of Fame Super Gold

Re: Cable Selection

Technically both T1 and E1 are comprised in G.703 standard.

The card you have can do E1 only. To further clarify, ask if the circuit is 1.5 mbps or 2 mbps, and if 2 mbps, if it is framed or unframed. You card would support both.

Thanks for the rating and good luck!

123
Views
9
Helpful
3
Replies
CreatePlease to create content