If your carrier is providing to you a ckt that is not on a DAC's system then the end equipment will decide the framing that is on the line. If going through a DAC's (Which I can say your carrier is providing to you because they are specifying M13) then I say you cannot run clear channel on this line. The carrier is providing off their DAC's the M13 framing that you need to apply the same framing from your equipment. Usually if you want Clear channel end to end then you need to order it as such...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...