Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can a VWIC3-4MFT-T1/E1 be used in place of a VWIC3-2MFT-G703?

Greetings,

I was wondering if you could replace 2x VWIC3-2MFT-G703 with a 1x VWIC3-MFT-T1/E1 running over clear channel E1 circuits if you configure the following:

A-end:

clock source internal

B-end:

clock source line

The reason for this is to consolidate the VWIC cards in order to migrate the service to a new platform?

Thanks in advance.

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Can a VWIC3-4MFT-T1/E1 be used in place of a VWIC3-2MFT-G703?

It can be used, however routers on both sides of the circuits will need to be configured for framed, 31 timeslots service.

3 REPLIES
Hall of Fame Super Gold

Can a VWIC3-4MFT-T1/E1 be used in place of a VWIC3-2MFT-G703?

It can be used, however routers on both sides of the circuits will need to be configured for framed, 31 timeslots service.

New Member

Can a VWIC3-4MFT-T1/E1 be used in place of a VWIC3-2MFT-G703?

Yes, I figured I would lose a timeslot of 64kbps on each circuit.

Thank you.

Hall of Fame Super Gold

Can a VWIC3-4MFT-T1/E1 be used in place of a VWIC3-2MFT-G703?

Thank  you for the nice rating and good luck!

232
Views
0
Helpful
3
Replies
CreatePlease login to create content