Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

JC
New Member

can any body how much bw configured on port from below mentioned config.

sh int GE-WAN3/1.720
GE-WAN3/1.720 is up, line protocol is up
  Hardware is GigabitEthernet Interface, address is 0013.7f6d.2bc0 (bia 0013.7f6d.2bc0)
  

  MTU 4474 bytes, BW 1000000 Kbit, DLY 10 usec,
     reliability 255/255, txload 29/255, rxload 130/255
  Encapsulation 802.1Q Virtual LAN, Vlan ID  720.
  ARP type: ARPA, ARP Timeout 04:00:00
  Keepalive not supported
     43483205208 packets input, 30686252708584 bytes
     4126465891920915 packets output, 125766989568145 bytes
 

 

  • WAN Routing and Switching
2 REPLIES

 Hi ,  Sub interface always

 

Hi ,

  Sub interface always share yours physical port speed settings , on your show results its 1 Gig Physical Interface . 

 

HTH

Sandy

JC
New Member

ya thats ok, but what is

ya thats ok, but what is the below value indicates.

 

43483205208 packets input, 30686252708584 bytes
 4126465891920915 packets output, 125766989568145 bytes

25
Views
0
Helpful
2
Replies