Can connect to router through VPN Client but cannot access any private LAN machines
I have a change in my network where I had to setup a public IP directly on my internet interface. I am hosting Crypto IPSec on my router to provide VPN service to my employees. After setting the public IP on my interface gig0/1 and making changes to the ip nat and ip routing, I am able to connect to the router and get authenticated, but I am not able to ping or access any of the LAN machines. Below is my config:
Current configuration : 16288 bytes
! Last configuration change at 12:08:24 TIME Sat Sep 21 2013 by admin
service timestamps debug datetime msec
service timestamps log datetime msec
boot system flash c1900-universal-mz.SPA.151-3.T1.bin
boot system flash c1900-universalk9-mz.SPA.151-3.T1.bin
Can connect to router through VPN Client but cannot access any p
I don't believe that is the problem. I am not using my gig0/0 in this scenario. This used to be one of my two internet lines, but since i am using Fiber now i only use gig0/1. That is why 0/0 is shutdown. Any other ideas? The problem is that the VPN users can be authenticated through gig0/1 but cannot ping any of the LAN servers (subnet 10.0.0.x).
I think it may be related to how i have configured my VPN public ip 1-to-1 NAT on the router. (
ip nat inside source static 22.214.171.124 126.96.36.199)
is there something wrong with the way this is setup?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.