Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Can I enable the GUI for WAN configuration of a 1921 router?

I have a Cisco 1921 in place with the security IOS so it is also acting as a firewall.

I am wondering if I can enable the GUI so I can configure it remotely. Is that possible?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Can I enable the GUI for WAN configuration of a 1921 router?

hi morris,

yes, you can do this via Cisco's SDM or CCP.  see URL and initial router conifg below. note that SDM is the old GUI and CCP is the latest.

http://www.cisco.com/en/US/products/sw/secursw/ps5318/index.html

http://www.cisco.com/en/US/products/ps9422/index.html

Router(config)#ip http server    OR

Router(config)#ip http secure-server

Router(config)#ip http authentication local

Router(config)#ip http timeout-policy idle 600 life 86400 requests 10000

Router(config)#username privilege 15 secret

Router(config)#line vty 0 4

Router(config-line)#privilege level 15

Router(config-line)#login local

3 REPLIES

Can I enable the GUI for WAN configuration of a 1921 router?

hi morris,

yes, you can do this via Cisco's SDM or CCP.  see URL and initial router conifg below. note that SDM is the old GUI and CCP is the latest.

http://www.cisco.com/en/US/products/sw/secursw/ps5318/index.html

http://www.cisco.com/en/US/products/ps9422/index.html

Router(config)#ip http server    OR

Router(config)#ip http secure-server

Router(config)#ip http authentication local

Router(config)#ip http timeout-policy idle 600 life 86400 requests 10000

Router(config)#username privilege 15 secret

Router(config)#line vty 0 4

Router(config-line)#privilege level 15

Router(config-line)#login local

New Member

Can I enable the GUI for WAN configuration of a 1921 router?

John,

Thanks again!!!! I will run these commands tomorrow. I can do most of the configs I need using the CLI, but there is something reassuring having the GUI as well.

I'll follow up with you again after I get this working tomorrow.

Thanks!

Can I enable the GUI for WAN configuration of a 1921 router?

hi morris,

sure just let this forum know if it worked.

on a personal note, GUI is nice but CLI is still the way to go.

6397
Views
0
Helpful
3
Replies
CreatePlease to create content